Analysis of the causes of the noise produced by the jigsaw

2020-08-22                         11:42:20

     For example, the noise of mechanical equipment is a very common phenomenon, but the noise will bring a lot of troubles to users, and we are also worried about the safety problems caused by noise. So how to find the noise source and how to remove the noise has become a problem in many people's minds. Today, I'd like to share with you the common causes of noise in the jigsaw to help you better solve such problems.

There are many reasons for the noise phenomenon of the board splicing machine. First of all, we will consider that if the motor, spindle rotation speed is relatively fast, it may lead to noise phenomenon. In addition, if the machine runs unevenly, it will lead to the resonance of the machine, which is also a cause of noise. Finally, when we install the saw blade to the panel machine, if the installation direction is opposite to the running direction of the main shaft, it will also cause noise.

The above is the introduction of the reasons for the noise of the board splicing machine. If you also encounter this situation, you must not forget to check according to the above contents. If you can not find the problem, you must find professional maintenance personnel to repair, because some noise may be the precursor of the collage machine failure, we should prevent it in the bud and avoid greater economic losses.