Operation process of panel collator

Now the mechanized workflow of a factory is gradually popularized, and now many factories have mechanized work. At present, the investment in opening a furniture factory can not only focus on equipment configuration. Seeing that others have several woodworking equipment and recruit several workers, they can produce products with good benefits. Some even develop rapidly, which seems to be no difficulty. But these are just appearances. It involves many aspects of knowledge and experience, and because of the rapid development of the industry, its knowledge and experience update very fast. We should also be prepared for the use of mechanization, and recommend the use of products such as square splicing machine and panel splicing machine.

It is very important that the correct operation of the panel splicing machine is aimed at the quality of the plate processing and that there is no danger for the workers. Therefore, when carrying out the work of the wood panel splicing machine, Linyi panel splicing machine manufacturer mainly carries out the operation according to the following sequence:

1. Brush glue on the plate to be spliced, and apply double-sided glue on the glued surface as far as possible.

2. Place the plate on the operating table according to the manufacturing process.

3. Push the manual pull valve so that the plate can be fixed after the pressure beam goes down.

4. Use jigsaw clips to compress the plates, and fix each plate with at least three jigsaw clips.

5. Remove the board and dry it.

The above is the operation process of the collator. Have you learned it?