Notes on the trial operation of panel collator

In order to ensure the excellent use effect of the splicing machine when you purchase the splicing machine, the first time after the installation of the equipment is to carry out the trial operation of the equipment. We must understand some related precautions about the trial operation of the splicing machine in advance. Today's editor here will share some precautions for the trial operation of the splicing machine:

Before the operation of the panel splicer, the connection of bolts, screws, nuts, joints and other connecting parts shall be checked carefully to see whether they are reliable. In addition, during the trial operation of the panel splicing machine, 7kg / C ㎡ pressure of compressed air is selected monthly, and the air pressure is adjusted to 6kg / C ㎡, which is used for turning plate and side pushing during splicing, and about 2.5kg/c ㎡ for pressure beam. Open the steam valve, check whether the steam of each heating pipe leaks, and then close it; turn the pneumatic change-over valve to make the pressure beam rise, and turn the pneumatic change-over valve to make the flap vertical. Observe whether the compressed air leaks, and adjust to make the pressure beam and flap move flexibly.

In addition, it is necessary to start the lifting motor of the assembly machine manufacturer's equipment to see whether the mechanism operates normally, and use the handwheel to fine tune the clearance to make it adapt to the thickness of the assembly, and then push the material to start, to see whether the oil cylinder, push plate mechanism and side push cylinder work normally.

The above content is the precautions for the panel splicer during the test run, hoping to bring help to you.