Company news

Solutions to different faults of jigger



It is also inevitable that mechanical equipment breaks down during work. There will also be some failures in the long-term use of the jigger, some of which can be avoided through daily maintenance, and some of which will occur after long-term work. The normal work can be maintained only after timely maintenance.

5d1c222fbb32d.jpg

There are different solutions to different faults. The pole plate of the jigger ignites. This problem is mainly caused by the pole plate discharge caused by short circuit or overcurrent. Usually, the glue overflows onto the upper and lower pole plates caused by too much glue, resulting in the occurrence of faults. The other is that the metal material in the wood causes a short circuit between the upper and lower plates. It can be seen that no matter what the cause is, this situation is mostly caused by short circuit. Please adjust these two parts carefully and pay more attention in your work.


Most of the over-current conditions are caused by improper operation. You can't operate the jigger skillfully. All friends you just contact should receive professional training. Correct operation can not only avoid over-current, but also avoid other problems.


Navigation column

Contact us

Name:Mr. XU

Tel:13563979777

Company:Linyi Senyuan Wood Machinery Co., Ltd.

Add:Machinery Industrial Park of Feixian Economic Development Zone (intersection of Xingda road and Xuyou Road)