Why the output stagnation of the jigsaw? How to solve this problem

2020-09-26              10:34:56

Jigsaw is a necessary machine in wood products processing industry. For the enterprises using splicing machine, when the material in the machine is almost finished, the machine will stop suddenly because of the production stagnation, resulting in the loss of cost. Today, I'd like to analyze the reasons for the above situation and help you better solve this problem

The output stagnation of the machine is mainly caused by the poor connection of the circuit

First of all, we need to check whether there is a problem with the control box and whether the connection between the control box and the distribution board is smooth. The control box is equivalent to the background control system of the computer; if there is a problem in the background, the problem will be directly reflected in the processing effect of the material.

It is then necessary to check each signal wire for signs of loosening or disconnection. It is also possible that the operator accidentally touched a signal line with his foot when walking, causing him to stop halfway. After splicing, the sheet metal can not output normally.

The output obstacle of panel welding machine is mainly caused by poor connection of circuit. In the process of use, we should pay close attention to the connection of lines, so as to successfully complete the established tasks and effectively utilize the material resources.

The above is the reason why the output of the jigsaw is stagnant. Do you understand it? For the jigsaw puzzle, you still have some unclear places to leave a message in the message section of the website. The editor will answer the question in the next issue of the article after you see it. We will continue to update the website. See you next week.